However it has since been established and tested quite a few times and the SID is not as important as all that so your procedure will work, and if you utilize it only for testing then you should be fine. So unless you can be absolutely sure you won't cause any unforeseen issues it's generally better to follow the recommendations. While normally you can safely say that your new machine will get a new RID, microsoft recommends using sysprep. Good Luck! Thanks for the update Lord_Arokh.The proper supported way of cloning an AD joined computer is by using sysprep. On Windows platforms with UAC enabled, you will need to right-click on cmd.exe and select “run as Administrator”. Run netdom.exe to change the password.You should reboot the domain controller and then force replication in the Active Directory Sites and Services MMC snap-in.Turn the Kerberos Key Distribution Center Service back on before rebooting.A reboot will do this for you, or you can remove them using KerbTray.exe. You can do this in the Services MMC snap-in. Turn off the Kerberos Key Distribution Center service.I haven’t done this for a while, but I think this works: If the broken machine is a domain controller it is a little bit more complicated, but still possible to fix the problem. Extra steps if the machine is a domain controller.For other platforms see this link: (WS.10).aspx ![]() On Windows Vista and Windows 7 you can get it from the Remote Server Administration Tools (RSAT). Windows Server 2008 and Windows Server 2008 R2 ship with netdom.exe you just have to enable the Active Directory Domain Services Where you get netdom.exe depends on what version of Windows you’re running. You need to make sure you have netdom.exe.User’s cached credential has the same problem as the machine’s private secret. You will be able to do disconnected authentication, but in the case of a reset machine, remember that you may have to use an old password. Another option is to unplug the machine from the network and log in with domain user. If you’re creative and resourceful you can hack your way I normally just log in with the local Administrator account by typing, “.\Administrator” in the logon window. You need to be able to get onto the machine.= DOMAIN\User format with rights to change the computer password = a domain controller in the joined domain How can I disjoin the domain if I cannot LOG IN!!!!!? Reboot the exchange server one more time, and it should be all good. Reboot the Exchange server and then go set your Exchange services back to automatic, or whatever they were originally. ![]() Power up the exchange server, logon as a local administrator and then rejoin the exact domain. Right click on it, and choose Reset Account Go to your Domain Controler and locate the computer account for your exchange server. Note what they are set at so you can put them back the way they were.ĭisjoin from the domain and then Shut exchange server off completely. (Not the domain Administrator account, it must be local)įirst stop and disable all Exchange services on the Exchange server. Make sure you have a local Administrator username and password for the exchange server. Gulab | MCITP: Exchange 2010-2007 | Skype: Gulab.Mallah | Blog: Thank you very much! This worked perfectly. Once the server is restarted after joining the server into the domain start the Exchange services. Disable and Stop all the exchange services.ĭisjoin the server and rejoin to the domain.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |